Zaxcom ZMT3

The ZMT3 is an ultra small bodypack transmitter using Zaxcom's digital recording & wireless features like NeverClip, PowerRoll and ZaxNet remote control. It is a wide-band transmitter featuring ZHD modulation. The ZMT3 transmitters are also capable of running all existing mono Zaxcom modulations maintaining compatibility with all Zaxcom receivers.

Small and durable, it's housed in a high strength, impact resistant nylon polymer casing with rounded edges, machined metal and rubber gaskets. This way the ZMT runs cool, the combination of the nylon composite case and its power efficiency make the heat transfer practically nonexistent.

The ZMT3 works with ZaxNet, Zaxcom's 2.4-GHz RF network that distributes remote control commands, timecode and IFB audio. With ZaxNet, one can remotely control transmitter settings such as gain, frequency channel selection, transport controls and output power levels. The ZMT3 also sends a quality control audio signal over ZaxNet, so when miking someone you don't have to go to the cart to hear how it sounds, you can use an ERX to listen to the mic right on the spot.

The ZMT3 can be ordered in one of two configurations:

• ZMT3.5: covering channels 26 through 38 (512 to 614 MHz)
• ZMT3.6: covering channels 36 through 49 (596 to 698 MHz)

Specifications

Transmitter:
• RF modulation: "Proprietary Digital Method"
• ZMT3.5 RF-range: 512 to 614MHz
• ZMT3.6 RF-range: 596 to 698MHz
• RF frequency step: 100KHz
• RF bandwidth in ZHD48 mode: 50KHz
• RF bandwidth in ZHD96 mode: 100KHz
• RF bandwidth in XR mode: 200KHz
• Channel separation in ZHD48 mode: as close as 100KHz (receiver dependent)
• Channel separation in ZHD96 mode: as close as 200KHz
• Channel separation in XR mode: 400KHz
• Antenna connector: 50 Ohms, SSMA female
• Emission designator: 180 KV2E, 100 KV2E, 50 KV2E
• FCC part: 74.861

Transmitter audio:
• Dynamic range: 128dB
• Distortion: 0.002%
• Frequency response in mode 0: 20Hz to 16kHz
• Frequency response in T & M mode: 0.2Hz to 16kHz
• High pass filter: Off or 30 to 220Hz (in 10steps of 6dB/octave)
• Mic power: 3.3 VDC
• Mic connector: 3-pin micro LEMO
• Input range: -60 to -30dBu
• Mic impedance: 6.8kOhm
• ADC bit-depth: 24 bits
• ADC sampling-rate: 48kHz

Timecode reader/generator:
• Timecode output: 3-pin micro LEMO
• Clock accuracy: 1.54 PPM (1 frame out in 6 hours)
• Timecode type: SMPTE
• Timecode frame-rates: 23.98, 24, 25, 29.97NDF, 29.97DF, 30NDF, 30DF

Internal recording:
• Media: MicroSD Card (Flash Memory)
• File format: .ZAX / converts to BWAV or MP3

2.4 GHz ZaxNet receiver:
• RF frequency range: 2.403 to 2.475GHz
• RF modulation: "Digital Spread Spectrum"
• RF frequency step: 0.001GHz (1MHz)
• RF bandwidth: 1MHz
• Channel separation: 2MHz
• Sensitivity: -96dBm

Physical:
• Weight: 62.3grs with battery
• Dimensions (H x W x D): 55.88 x 40.64 x 13.97 in mm
• Display: graphic OLED

Power:
• Power output: 25/50/75mW (software selectable)
• Battery type: NP-50
• Battery life: up to 5.5 hours


 

Zaxcom ZMT3
 
Art.nr: K029016

€1.665,00
Freq. optie
Aantal

    Wenslijst
Zaxcom miniatuur beltpack zender en recorder, werkzaam op 1x NP-50 accu. Schakelbereik 102 Mhz.
The ZMT3 is an ultra small bodypack transmitter using Zaxcom's digital recording & wireless features like NeverClip, PowerRoll and ZaxNet remote control. It is a wide-band transmitter featuring ZHD modulation. The ZMT3 transmitters are also capable of running all existing mono Zaxcom modulations maintaining compatibility with all Zaxcom receivers.

Small and durable, it's housed in a high strength, impact resistant nylon polymer casing with rounded edges, machined metal and rubber gaskets. This way the ZMT runs cool, the combination of the nylon composite case and its power efficiency make the heat transfer practically nonexistent.

The ZMT3 works with ZaxNet, Zaxcom's 2.4-GHz RF network that distributes remote control commands, timecode and IFB audio. With ZaxNet, one can remotely control transmitter settings such as gain, frequency channel selection, transport controls and output power levels. The ZMT3 also sends a quality control audio signal over ZaxNet, so when miking someone you don't have to go to the cart to hear how it sounds, you can use an ERX to listen to the mic right on the spot.

The ZMT3 can be ordered in one of two configurations:

• ZMT3.5: covering channels 26 through 38 (512 to 614 MHz)
• ZMT3.6: covering channels 36 through 49 (596 to 698 MHz)

Specifications

Transmitter:
• RF modulation: "Proprietary Digital Method"
• ZMT3.5 RF-range: 512 to 614MHz
• ZMT3.6 RF-range: 596 to 698MHz
• RF frequency step: 100KHz
• RF bandwidth in ZHD48 mode: 50KHz
• RF bandwidth in ZHD96 mode: 100KHz
• RF bandwidth in XR mode: 200KHz
• Channel separation in ZHD48 mode: as close as 100KHz (receiver dependent)
• Channel separation in ZHD96 mode: as close as 200KHz
• Channel separation in XR mode: 400KHz
• Antenna connector: 50 Ohms, SSMA female
• Emission designator: 180 KV2E, 100 KV2E, 50 KV2E
• FCC part: 74.861

Transmitter audio:
• Dynamic range: 128dB
• Distortion: 0.002%
• Frequency response in mode 0: 20Hz to 16kHz
• Frequency response in T & M mode: 0.2Hz to 16kHz
• High pass filter: Off or 30 to 220Hz (in 10steps of 6dB/octave)
• Mic power: 3.3 VDC
• Mic connector: 3-pin micro LEMO
• Input range: -60 to -30dBu
• Mic impedance: 6.8kOhm
• ADC bit-depth: 24 bits
• ADC sampling-rate: 48kHz

Timecode reader/generator:
• Timecode output: 3-pin micro LEMO
• Clock accuracy: 1.54 PPM (1 frame out in 6 hours)
• Timecode type: SMPTE
• Timecode frame-rates: 23.98, 24, 25, 29.97NDF, 29.97DF, 30NDF, 30DF

Internal recording:
• Media: MicroSD Card (Flash Memory)
• File format: .ZAX / converts to BWAV or MP3

2.4 GHz ZaxNet receiver:
• RF frequency range: 2.403 to 2.475GHz
• RF modulation: "Digital Spread Spectrum"
• RF frequency step: 0.001GHz (1MHz)
• RF bandwidth: 1MHz
• Channel separation: 2MHz
• Sensitivity: -96dBm

Physical:
• Weight: 62.3grs with battery
• Dimensions (H x W x D): 55.88 x 40.64 x 13.97 in mm
• Display: graphic OLED

Power:
• Power output: 25/50/75mW (software selectable)
• Battery type: NP-50
• Battery life: up to 5.5 hours


 
Uw naam: *
Uw e-mailadres: *
E-mailadres ontvanger: *

Voer de tekens in die in onderstaande afbeelding worden getoond

Code vernieuwen

Stuur naar een vriend